I've tried adjusting the position by pulling on the tube or tilting it at various angles, but the water just leaks out of different places.Ĭould it be because it's the only line coming off the main poly tube? I'm planning on adding several more soaker lines to hit the rest of our garden areas, which will no doubt distribute some of the pressure. I've done this before, with some tiny leaks (just some drips), but never such a big leak. A Learners Polish-English Dictionary is intended primarily for the. The coupler sits perpendicularly to the tubing.
It isn't positioned at a weird angle, the hole isn't too big, and I did push in the coupler all the way until it "snapped" into place. The hole where the barbed coupler fits into the poly tube is leaking (and by leaking I mean spraying water about 12-16" into the air). Near the end of that main line (maybe 8' from the end) a barbed coupler is inserted, with the other end going into about 10' of 1/8" soaker hose that is terminated by a goof plug.
The 1/2" poly line runs from our outdoor spigot about 30' then is terminated at the end by folding it over clamping it at the end with a zip tie. I'm installing a simple drip irrigation system for our garden using Rain Bird products. It's a pretty basic setup, but I'll describe how it's laid out in my particular case: When drip irrigation connectors leak, it is usually because the hole that was punched into the 1/2 hose is too large. I'm wondering how others have fixed leaks in the fittings that are supposed to just work by popping them into the polyurethane tubing. This seems to be a common issue (drip line barbed couplers leaking) and I can't find any answers about this online.